Tutorial on Simulation of Servo Motor on proteus

  A tutorial on simulating a servo motor with an Arduino in Proteus:

Step 1: Setting up the Circuit

1. Open Proteus Design Suite and create a new project.
2. Place an Arduino board (like Arduino Uno) from the Components Library onto the workspace In proteus.
3. Add a servo motor (usually found in the Motors category) onto the workspace.
4. Connect the control pin (usually denoted as "S" or "Signal") of the servo motor to one of the PWM pins of the Arduino (e.g., pin 9).

Connect the VCC and GND pins of the servo motor to the corresponding VCC and GND pins of the Arduino.

Step 3: Simulating in Proteus

1. Go to the "Debug" menu and select "Compile" to compile your Arduino code.
2. Once compiled successfully, click on the "Run Simulation" button to start the simulation.
3. You should see the servo motor in Proteus start sweeping back and forth between 0 and 180 degrees.

Step 4: Observing the Simulation

You can observe the behavior of the servo motor in the simulation window. You'll notice the servo motor moving according to the code, sweeping back and forth.

Step 5: Experimentation

Feel free to experiment with the code and the circuit. You can change the angles, the speed of movement, or add additional functionalities to control the servo motor based on sensor inputs or user commands.